Table of Contents
Advertisement
5.2. Wiring
7
7
7
10
7
10
10
7. The terminal block of the camera can be unclipped to make installation easier.
8. Connect your camera to the mains (L IN = 230 V phase / N IN = 230 V neutral / Earth must not be
connected) as shown. If you wish, you can connect a 230 V AC light (L OUT = 230 V phase / N OUT
= 230 V neutral) to your light in order to control it using your camera, its motion detection or the
Philips WelcomeEye application. The lighting power should not exceed 1000 W.
9. Once wiring is complete, reclip the terminal block to your camera.
10. Hang the top of your camera on the base on the wall.
11. Place the camera on the wall and then tighten the screw onto the base to secure the camera to
the wall.
12. You can now reconnect the power supply and continue setting up the camera.
8
8
8
L
L
L
N
N
N
11
8
11
11
11
WelcomeEye View / V1
9
9
9
12
12
12
12
9
5
Advertisement
Table of Contents
