Siemens DMS8000 MP4.81 Operation Manual page 22

2 Configuring intrusion control units
Configuring an SPC4000/SPC5000/SPC6000
22
Building Technologies
CPS Fire Safety
2. Select the path:
Supervisor System Settings > MM8000 System > Physical configuration >
Station (e.g. My Station) > Channels Collection
3. Click the NS8021 FlexC Driver or the NS8013 SPC Driver icon in the icon
toolbar to add the driver to the channels collection.
a The new driver node appears in the station folder.
4. Configure the network parameters for the driver:
– NS8021 FlexC Driver: TCP Port (the RCT TCP Port of the panel
configuration) and Receiver ID (the RCT ID of the panel configuration).
– NS8013 SPC Driver: UDP Port or TCP Port, and Receiver ID, which should
match the corresponding values in the EDP client list of SPC.
Note: You can check the valid values in the Client Configuration list of the
Node tab of the SPC units after importing the metafile.
Adding the intrusion system folder
1. In the left-hand bar, click the Generic Template icon
a A new node is added to the project structure.
2. Select the new folder and name it in the Description field of the Node tab.
Adding the intrusion system node
1. Select the new folder.
2. In the left-hand bar, select the Intrusion folder icon .
3. In the menu that appears, select the appropriate icon to add a new intrusion
system node.
a A new node is added to the project structure.
Note: You can customise the default name of the new node typing in a new name
in the Description field of the Node tab, but do not customise it now since it will be
renamed during the metafile import.
.
A6V10359489_a_en
30.09.2016