Table of Contents
Advertisement
● Logitech Tap Receiver
● Dongle Transceiver
● 100 V to 240 V Power Supply with International adapter set
● 297 cm (116.92 in.) Cat5e cable
● 700 cm (275.59 in.) Cat5e cable
● HDMI 1.4a cable 200 cm (78.74 in.)
● VESA mounting screws (4)
● Microfiber cloth
● Documentation
Logitech Tap IP consists of:
● Tap IP Touch Controller
● VESA mounting screws (4)
● Microfiber cloth
● Documentation
Follow these steps to connect the Logitech Tap to your OptiPlex 7080 Micro XE.
1. Place the Logitech Tap on a table.
2. Turn the Logitech Tap over.
3. Using the thumbscrews, open the bottom cover of the Logitech Tap.
4. Remove the plastic sheet at the rear of the Logitech Tap.
5. Connect a single Ethernet cable and optional HDMI cable (applicable for Cat5e Kit Touch Controller for screen sharing) to
the Logitech Tap. For more information about connecting cables to Logitech Tap, see the Tap Touch Controller installation
guide that is shipped with the device.
6. Connect the Ethernet cable to your OptiPlex 7080 Micro XE.
10
Set up the Dell Large Conference Monitor Room Kit for Microsoft Teams Rooms
Advertisement
Table of Contents
