Preparation Before Threading The Needles - Brother 884-B20 Owner's Manual

Using spun thread
CAUTION
Turn off the machine.
IMPORTANT
- Do not press the air threading pushbutton while
threading with the sewing thread, otherwise the
machine may be damaged.
1. Use the air threading to thread the looper with
spun thread.
2. Cut the spun thread 20 to 30 cm (8 to 12
inches) from the looper thread insertion hole 1 .
3. Thread the machine with the sewing thread up
to the looper thread insertion hole.
4. Tie the sewing thread to the spun thread 2 .
5. Pull the spun thread coming out of the hole
at the end of the looper until enough sewing
thread has come out 3 .

Preparation before threading the needles

CAUTION
For safety, turn off the machine before threading.
1. Raise the presser foot lifting lever to raise the
presser foot.
2. Turn the handwheel so that the mark on the
handwheel <A> is aligned with the line on the
machine <B>.
NOTE:
When threading the needles after threading the
loopers, the handwheel does not need to be
turned since the mark on the handwheel and the
line on the machine have already been aligned.
If the machine has been turned on, turn it off.
17