Powering The Machine; Turning Direction Of The Handwheel; Opening/Closing The Front Cover And The Knife Cover - Brother 884-B20 Owner's Manual

Powering the machine

Turning on the machine
1. Insert the three-pin plug into the foot controller
inlet on the bottom right side of the machine.
Insert the power supply plug into a power
outlet.
2. Turn the main power and light switch <A> to "I"
mark (to "O" mark to turn off).
Operation
When the foot controller is pressed lightly, the
machine runs at a low speed. As the foot controller
is pressed further, the machine increases speed.
When the foot controller is released, the machine
stops.
1 Slower 2 Faster
NOTE (For U.S.A. only):
Foot controller: Model KD-1902A
This foot controller can be used on the machine
with product code 884-B20 and 884-B21
* The product code is shown on the machine rating
plate.

Turning direction of the handwheel

The handwheel <A> turns in a counterclockwise
direction (direction of arrow). This direction is the
same as an ordinary home sewing machine.
Before threading the machine, turn the handwheel
so that mark <C> on the handwheel is aligned with
line <B> on the machine.
6
Opening/Closing the front
cover and the knife cover
It is necessary to open the front cover and the
knife cover when threading this machine.
To open the front cover, grasp <A> with your finger
and move the cover in the direction of the arrow.
To open the knife cover, slide it to the right 1 , and
then move it in the direction of the arrow 2 .
Closing the front cover also closes the knife cover.