Restart - Panasonic 5054 Technical Manual

12

Restart

The display unit will restart when one of the following occurs:
When powered up
•
• After address setting
If the contact with the control unit is re-established after the message:
•
"No contact with Control unit"
If a program memory fault existed in the unit, the following message will display:
"Memory fault in program area (n)" (n=1 or 2)
The display unit will not work, and a fault message will be shown in the FDCIE:
• FT1020G3: "FAULT: No reply, display unit xx, control unit xx"
FT128: "FAULT: No reply EPU x"
•
If an SSD memory fault in 5054 or no SSD downloaded, the display unit will still work since
the alarm texts will be sent out from the FDCIE.
A fault message will be shown in the FDCIE:
FT1020G3: "FAULT: Site specific data, display unit xx, control unit xx"
FT128: "FAULT: Site specific data (SSD), EPU x"
30
Technical Manual
5054 Rev 0
For Firmware V2.0.x