Mounting - Panasonic 5054 Technical Manual

10

Mounting

The display unit must be mounted on the wall. Screws for wall mounting are not supplied.
The following procedures can be used to mount the display unit:
1. Remove the two screws (Torx T10) at the bottom of the display unit and open the
cover.
2. Disconnect the loudspeaker cable, see left arrow below.
3. Remove terminal block J5 from the PCB as shown below (right arrow).
4. Cut out the required number of knockouts, into the top, bottom or rear.
5. Enter the cables into the box.
Note: The cable length should be as long as possible when entering from top. Move the ground
bar plate to the lower position when entering from top.
6. Mount the box on the wall, see section 10.1 next page.
Tip: Use the internal level vial to make sure the display unit is levelled.
26
Technical Manual
5054 Rev 0
For Firmware V2.0.x