Toro 22159 Installation Instructions Manual

Rear Bag Kit
For PT21 Lawn Mowers
Model No. 22159
Installation
Loose Parts
Use the chart below to verify that all parts have been shipped.
Step
1
Grass bag
2
Bagging blade
The grass bag is fully assembled and ready to use.
Step
1
Installing the Grass Bag
Parts needed for this step:
1 Grass bag
Procedure
Use the grass bag when you want to collect grass
and leaf clippings from the lawn.
If the side discharge chute is on the mower,
remove it and lock the side discharge door before
bagging the clippings.
The blade is sharp; contacting the blade can
result in serious personal injury.
Stop the engine and wait for all moving parts
to stop before leaving the operating position.
1. Raise and hold up the rear door (Figure 1).
© 2007—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Description
2. Remove the rear discharge plug.
3. Install the bag onto the door rod (see inset in
4. Lower the rear door.
5. To remove the bag, reverse the steps above.
Register at www.Toro.com.
Form No. 3358-309 Rev A
Installation Instructions
Qty.
1 Install the grass bag.
1 Install the bagging blade.
Figure 1
Figure 1).
Original Instructions (EN)
Use
Printed in the USA
All Rights Reserved