Configure
5.2 Configuration of the active backplane bus in the TIA Portal
5.2
Configuration of the active backplane bus in the TIA Portal
The representation of a station in the graphics area of the device view consists of 2 main
areas:
①
②
Replacing a rack
To replace the U-connector rack for an active backplane bus, you can use the "Change device"
function.
Switch to the device view.
Then there are 2 options for starting the "Change device" function:
• Via the shortcut menu
– Right-click in the rack area (1) or on the name of the rack (in the figure above e.g.
– Select "Change device" from the shortcut menu. A dialog window opens.
– Select another rack and click "OK". The replacement of the rack starts.
• Via drag-and-drop
– The hardware catalog is open. Select the "Rack" folder and navigate through the
– Select the desired rack.
– Drag the rack into the rack area (1) and place it there.
18
Rack area
Module area (slots)
"Rail_0").
subfolders to the desired rack.
Active backplane bus ST 1+12 slot, active backplane bus ST 1+8 slot, active backplane bus ST 1+4 slot
Equipment Manual, 07/2020, A5E46240468-AB