Prerequisites
Purpose
This document describes how to install a remote exposure switch system on a
Mobilett Plus/ Plus E/ Plus M/ Plus HP.
Important note
After the installation is done, separate the last chapter, "the Supplement to the Instruc-
tions for Use", from the document. It is important to insert this chapter into the Instructions
for Use for the Mobilett product affected, unless the remote exposure switch system
already is described in the Instructions for use. This shall be done to help the user how to
use the remote switch system after the installation.
Parts required
Remote exposure switch system kit, including:
•
Two remote controls (one spare)
•
IR sensor with modular cable
•
PCB electronics package with flat cable
•
Ferrite core
•
Washers
•
Ground connector cable
•
Tie-mounts
•
Cable ties
•
This instruction
Tools required
•
Standard installation tools
•
Masking tape
•
Electric drill with 13 and 4,8 mm drill bits
Time required
•
Approximately one hour for one person
Siemens-Elema AB
Solna, Sweden
SPR8-220.031.02
Rev. 02
11.02
1
Page 1 of 2
Mobilett Plus/ E/ M/ HP
SPS-UD
1 - 1
1
1
1
1
1
Service