Siemens Mobilett Plus Installation Instructions Manual page 9

Installation
7.
Fig. 3 Mounting of remote sensor
8.
Module connector
Fig. 5
Siemens-Elema AB
Solna, Sweden
Refer to Fig. 3 and Fig. 4 and mount the remote sensor to the Mobilett arm cover
with the hardware supplied. Make sure that the cable is secured above the IR-
sensor to avoid the sharp edges of the thin metal cover below (pos 8 / Fig. 1).
Leave a vertical loop in the remote sensor cable and use cable ties to wrap the
cable to the existing cable harness in the Mobilett articulated arm making certain
the cable will not become cut or crimped, see Fig. 4 and Fig. 5. Assure that the
cable will not be in contact with the axis of the articulated arm (pos 1 / Fig. 5).
Fig. 4 Leaving a vertical loop of the cable
Remote sensor
SPR8-220.031.02
Rev. 02 11.02
1
Page 3 of 8 Mobilett Plus/ E/ M/ HP
SPS-UD
2 - 3
Service