Table of Contents
Advertisement
Sytronix SvP 7030 IMC
40 / 186
Mechanical installation of the motor-pump unit
7
Installation
Before starting to install the system, you should have the following documents
at hand:
7.1
General information
This chapter describes the assembly and installation of the Sytronix system SvP
7030 IMC at the place of use as well as the connection to the hydraulic system
and to the electrical system of the machine. Details on the installation in the
machine and in particular on the overall functionality and operating logic can
be found in the instructions and/or documentation for the complete machine.
These installation instructions are tailored to the use of the Sytronix system
SvP 7030 IMC. Observing these instructions is a decisive factor for the service
life of the units.
The instructions refer to standard types and standard installation conditions.
Special installation situations require special, additional measures to be taken
on the unit.
7.2
Unpacking
● Dispose of the protective foils and packaging material in accordance with
7.3
Mechanical installation of the motor-pump unit
7.3.1
Installation conditions
● Adhere to the limits specified for temperature, viscosity, cleanliness of the
● Make sure that the housing of the pump is filled with hydraulic fluid. This
● To achieve favorable noise values, decouple all connecting lines from all
● Make certain that the suction line, case drain line, and return line flow into
Bosch Rexroth AG
Insufficient space!
CAUTION
Risk of bumping or bruising when components, oper-
ating and display elements are unfavorably arranged.
−
Provide for sufficient installation space.
−
Observe the installation instructions.
−
Wear personal protective equipment.
Removed protective plugs!
CAUTION
Risk of falling or slipping due to draining test oil.
−
Only remove protective caps directly before con-
necting the ports.
Parts falling out!
CAUTION
If the packaging is not opened correctly, parts may fall
out and cause injury.
−
Put the packaging on level, bearing ground.
−
Only open the packaging from the top.
the national regulations of your country.
hydraulic fluid, etc. in the data sheets and in the chapter "Transport and
storage" above.
must also be observed during longer periods of standstill, because the
Sytronix system may drain via the hydraulic lines.
components that can vibrate (e.g. tank) using elastic elements.
the tank below the minimum fluid level in all operational states.
RE 62312-B, 03.2022
Advertisement
Table of Contents
