Advertisement
Settings
Network Easy Setting
After completing "Easy Setting", you can continue
with "Network Easy Setting".
Select "Wired" or "Wireless", then press
[OK].
e.g., [BWT800]
Network Easy Setting
Settings and tests for connection required
for home network and the Internet will be
conducted.
First, please select a connection mode.
Current setting
: Wired
LAN cable connection:
Connect a LAN cable to the unit and select "Wired".
Wireless LAN connection:
Select "Wireless".
Wired
Wireless
OK
RETURN
"Wired" connection
Follow the on-screen instructions and make
the following settings.
≥Network Easy Setting ( Home Network Connection
Check )
≥Home Network ( DLNA ) Server function
≥Network Easy Setting ( Internet Connection Test )
Network Easy Setting
Network Easy Setting have been finished.
Press OK.
OK
RETURN
This screen appears, Setup is complete.
Press [OK].
When you experience problems with settings
(
17)
"Wireless" connection
Before beginning wireless connection setup
≥Obtain your Network name (SSID
≥If your wireless connection is encrypted please
be sure that you know your encryption key.
≥[BWT700] If "Wireless LAN Adaptor is not connected."
is displayed, check that the Wireless LAN Adaptor is
fully inserted. Alternatively, disconnect and
reconnect it. If there is still no change in the display,
consult your dealer for advice.
16
VQT3C13
Select "Search for wireless network" or
"WPS (PUSH button)" and then follow the
on-screen instructions and make the
settings.
Wireless Settings
∫ Search for wireless network:
≥When you select "Search for wireless network", the
available wireless networks will be displayed. Select
your network name and press [OK].
–If your Network name is not displayed search
again by pressing the "Red" button on the remote
control.
–Stealth SSID will not be displayed when you select
"Search for wireless network". Enter Manually by
using "Wireless Settings". (
≥If your wireless network is encrypted, Encryption
Key Input Screen will be displayed.
Input the encryption key of your network.
∫ WPS (PUSH button):
If your Wireless router supports
WPS (PUSH button), you can
easily perform the settings by
pressing WPS button on it.
WPS (Wi-Fi Protected Setup) is a
standard that facilitates settings
relating to the connection and
security of wireless LAN devices.
1 Press WPS button or corresponding button of
Wireless router until the lamp starts flashing.
≥For details, refer to the operating instruction of
2 Press [OK].
An SSID (Service Set IDentification) is a name
§1
used by wireless LAN to identify a particular
network. Transmission is possible if the SSID
matches for both devices.
Wi-Fi Protected Setup-compatible Wireless router
).
§2
§1
may have the mark.
Select a connection method to wireless access point.
Please refer to the operating instructions of your wireless
access point about connection methods.
Search for wireless network
WPS (PUSH button)
OK
RETURN
Wireless router.
100)
e.g.,
2
Advertisement
