Brother MFC-J2320 Service Manual page 56

Code 1 Code 2
A8 01 Receive RTN or PIN or ERR (sending side.)
A9 01 Send RTN or PIN or ERR (receiving side.)
AA 18 Receive buffer full during receiving into memory.
B0 02 Unable to receive the next-page data.
Unable to receive polling even during turn-around
B0 03
transmission due to call reservation.
B0 04 PC interface error
Communication cancelled by depressing stop key before
BF 01
confirming FAX communication.
Communication cancelled by depressing stop key after
BF 02
confirming FAX communication.
C0 01 No common modulation mode or polling failed.
C0 02 Unable to detect JM.
C0 03 Unable to detect CM.
C0 04 Unable to detect CJ.
C0 10 V. 34 negotiation or training not finished.
C0 11 Modem error detected during V. 34 negotiation or training.
C0 20 Modem error detected during sending of commands.
C0 21 Modem error detected during receiving of commands.
C0 22 Control channel connection time-out.
C0 30 Modem error detected during sending of image signals.
C0 31 Modem error detected during receiving of image signals.
E0 01 Failed to detect 1,300 Hz signal in burn-in operation.
E0 02 Failed to detect PB signals in burn-in operation.
E0 03 Command not detected from RS232C in burn-in.
Cause
2-19
Refer to
page:
Section
4.9.3
"A commu-
nications
error
occurs"
Confidential