Prop Shaft Removal - Polaris RZR 900 2015 Service Manual

19. Install and tighten the small clamp
appropriate clamp tool.
Axle Boot Clamp Tool: PU-48951
or
CV Boot Clamp Pliers: 8700226
20. Pull out on the drive shaft to center the joint in the
housing. Slide a straight O-ring pick or a small
slotted screw driver between the large end of the
boot and the joint housing and lift up to equalize the
air pressure in the boot.
21. Position the boot lip in its groove. Install and tighten
r
the large clamp using the appropriate clamp tool.
Axle Boot Clamp Tool: PU-48951
or
CV Boot Clamp Pliers: 8700226
9926814 R08 -
Manual
© Copyright Polaris Industries Inc.
e

PROP SHAFT REMOVAL

using the
1. Remove the center console by removing the five push
rivets
shifter boot
2. Safely lift and secure the vehicle.
3. Remove the right side front wheel.
4. Draw a paint line on the front prop shaft yoke to the
front gearcase input shaft to ease alignment on
installation.
5. Locate the prop shaft roll pin and use the Roll Pin
Removal Tool (PN 2872608) to remove the roll pin.
Discard the roll pin.
6. Draw a paint line (if none are present) between the
front prop shaft yoke and the splines on the rear prop
shaft for proper alignment on installation.
7. Remove the two fasteners
support bearing to the frame.
2015-2016 RZR 900
q w
, two T-40 Torx screws
e
through the console.
Roll Pin Removal Tool:
2872608
r
retaining the prop shaft
2016 RZR S 1000 Service
FINAL DRIVE
and push the
7
7.19