Taillights; Dash Led Light - Polaris RZR 900 2015 Service Manual

3. Carefully lift and remove headlamp assembly from
the bumper.
Headlamp Installation
1. Install the headlamp adjustment springs onto the front
bumper mounting bosses.
2. Insert the three T-25 headlamp mounting screws into
the headlamp assembly mounting holes.
3. Maneuver the headlamp assembly into position. Be
sure all three headlamp springs
q
screws are properly aligned with mounting bosses
③ on the front bumper.
4. Fully tighten all three headlamp screws until the
headlamp assembly is fully seated. Back headlamp
mounting screws off 1/8" to 1/4" (2-3 turns).
5. Install the front bumper as shown in Chapter 5 if
previously removed.
6. Connect headlamp electrical connector to the
headlamp assembly.
7. Perform the "Headlamp Adjustment" procedure as
shown in this chapter.
9926814 R08 -
Manual
© Copyright Polaris Industries Inc.

TAILLIGHTS

Taillight Replacement
Before replacing the taillight(s), use a digital multi-meter
to test the harness to ensure the lamp is receiving 12
volts and that a ground path is present.
1. Disconnect the wire harness
2. While holding the taillight assembly, remove the three
nuts
from the rear fascia.
w
and mounting

DASH LED LIGHT

The vehicle is equipped with an LED light below the dash
that illuminates when the key is turned on. This LED will
stay on for approximately 20 seconds after the key has
been turned off.
2015-2016 RZR 900
q
.
w
retaining the taillight assembly and remove it
2016 RZR S 1000 Service
ELECTRICAL
11
11.23