Sanyo FWZH776F Owner's Manual page 25

Network Function
FWZH776/676F
11
Select "Use" or "Do Not Use" using
[ K / L ], then press [ OK ].
• If you Select "Use", "Standby Setting" will be
"Normal Standby" automatically. 'Unit Name'
screen will appear.
• If you Select "Do Not Use", please move on to
'HDMI CEC' below.
Unit Name
FWZH776/676F
12
Select "Yes" or "No" using [ K / L ],
then press [ OK ].
• If you Select "Yes", Unit Name Input Screen
will appear.
Enter the new Unit Name using the On-screen
Software Keyboard.
If you finish entering the Unit Name, press
[ OK ].
• 'HDMI CEC' screen will appear.
HDMI CEC
When this unit and TV are connected via HDMI Cable, it
is possible to use the HDMI CEC function.
This function may not work properly depending on the
TV connected to this unit.
13
Select "Yes" or "No" using [ K / L ],
then press [ OK ].
• If you Select "Yes", "Standby Setting" will be
"Normal Standby" automatically.
• 'Standby Setting' screen will appear.
Standby Setting
14
Select "Normal Standby" or "Energy
Saving Standby" using [ K / L ], then
press [ OK ].
• If you Selected "Yes" for 'HDMI CEC' the unit
is in "Normal Standby" mode where the unit
Starts Faster than "Energy Saving Standby".
"Normal Standby" will increase the Power
Consumption when the Power is Off in Standby
mode.
• If you did not select 'HDMI CEC' then you can
select "Normal Standby" or "Energy Saving
Standby", where HDMI CEC and Network
Functions (never available in FWZH576F) will
be not available. "Energy Saving Standby" will
reduce the Power Consumption during Standby
mode rather than "Normal Standby".
• 'FL Dimmer' screen will appear
FL Dimmer
15
Select a desired item using [ K / L ],
then press [ OK ].
Front Panel Display gets Darker
when the unit turned Off.
Auto
Front Panel Display gets Brighter.
Bright
Front Panel Display gets Darker.
In STANDBY / ON mode, panel
Dark
lighting in On.
Off
In Standby mode, panel lighting is
Off.
• 'Exit' screen will appear.
16
Select "Completed" using [ K / L ],
then press [ OK ].
• "Initial Setting" is finished.
■
Guide to the Software Keyboard
1. Press [ the Number buttons ] Repeatedly to enter
the Desired Character.
• If a Desired Character is the same button as the
Previous Character, press [ 1 (Cursor)], then press
the same button.
• To change the Number Set, press [ INFO ].
To change the Character Set, press [ INFO ].
• To Delete Characters, press [ CLEAR ]
2. When you finish entering Numbers, Letters and
Characters, then press [ OK ].
Note(s)
• In Character Set, the Number 1 pushed Repeatedly
can be used to Input the following Symbols,
– ., @, -, _, /, :, !, ", #, $, %, &, ', (, ), *, +, ,,
;,
<, =, >, ?, [, \, ], ^, `, {, |, }, ~
Exit
EN - 25
EN