Network; Network Settings - Sanyo FWZH776F Owner's Manual

8. NETWORK

FWZH776/676F
This section describes the procedures for Network
setup. By performing the Network Connection setup,
you can use the Network features, such as Network
Update function.

Network Settings

You can Select either wireless Connection or Wired
Connection.
If you connect this unit to the Network
using an Ethernet Cable, Select "Wired"
Wired
to connect to the Internet.
If you have a Wireless Networks, Select
Wireless
"Wireless" to connect to the Internet.
1
Press [ HOME ], then Select "Settings"
"General Settings"
then press [ OK ].
Network Connection
2
Select "Network Connection", then
press [ OK ].
• Connecting method screen will appear.
■
For Wired Connection
For Wired Connection, a Network Connection will
automatically be established.
AUTO
3
Select "Wired" using [ K / L ], then
press [ OK ].
4
Select "Auto" using [ K / L ], then
press [ OK ].
• Network Connection will automatically be
established, then Connection test will Start
and the test result will be Displayed. Refer to
'Connection to the Network' on page 18.
5
Press [ OK ] to complete the Network
setup.
• Press [ (EXIT) ] to Exit.
Manual
3
4
IP Address Setting IP Address Setting
IP Address : Auto(DHCP)
Select "IP Address Setting" using [ K/ L ], then
1.
press [ OK ].
• You will be asked to Select "Auto(DHCP)" or
Select "Auto(DHCP)" using [ K/ L ], then press
2.
[ OK ].
• Please move on to 'DNS Setting Mode'.
IP Address : Manual
"Manual" lets you manually configure the IP setting.
"Network",
Select "IP Address Setting" using [ K/ L ], then
1.
press [ OK ].
Select "Manual" using [ K/ L ], then press [ OK ].
2.
Select "IP Address" using [ K/ L ], then press
[ OK ].
• IP Address entry window will appear.
3. Enter an IP Address using [ the Number
buttons ].
Press [ OK ] when at the cell to the far right.
• Enter an IP Address after checking the
• If an IP Address is unknown, check the IP Address
• Please move on to 'Subnet Mask'.
Subnet Mask : Manual
Select "Subnet Mask" using [ K/ L ], then press
4.
[ OK ].
• Subnet Mask entry window will appear.
5. Enter the Subnet Mask using [ the Number buttons ].
• Enter the Subnet Mask after checking the
6. Press [ OK ] when at the Cell to the far right.
• Please move on to 'Default Gateway'
Select "Wired" using [ K / L ], then
press [ OK ].
Select "Manual" using [ K / L ], then
press [ OK ].
"Manual".
specifications of your Router.
of other devices (e.g. PC connected with a LAN
Cable). Then, in the cell to the far right, assign a
different number from those other devices.
specifications of your Router, then enter the same
Numbers in the cells.
Continued on next page.
EN
EN - 43