Motorola MVME2400 Series Installation And User Manual page 18

Preparation and Installation
1
PCI Mezzanine Cards (PMCs)
VMEsystem Enclosure
System Console Terminal
1-4
The PMC slots on the MVME2400x board are IEEE P1386.1 compliant.
P2 I/O-based PMCs that follow the PMC committee recommendation for
PCI I/O when using the 5-row VME64 extension connector will be pin-out
compatible with the MVME2400x.
The MVME2400x board supports both front panel I/O and rear panel P2
I/O through either PMC slot 1 or PMC slot 2. 64 pins of I/O from slot 1 and
46 pins of I/O from slot 2 are routed directly to P2.
Your MVME2400x board must be installed in a VMEsystem chassis with
both P1 and P2 backplane connections. It requires a single slot, except
when PMCspan carrier boards are used. Allow one extra slot for each
PMCspan.
In normal operation, connection of a debug console terminal is required
only if you intend to use the MVME2400x's debug firmware, PPCBug,
interactively. An RJ45 connector is provided on the front panel of the
MVME2400x for this purpose.
Computer Group Literature Center Web Site