NEC Express5800 Series Manual page 24

Page.24
Notes on using the Mezzanine Card (Type1 , Type2)
When installed mezzanine card (Type1, Type2) on CPU blade, please be careful about below.
When a right switch module isn't mounted on the switch module slot of blade enclosure, an error message is shown to the
SIGMABLADE monitor of blade enclosure.
Error message
SWMn IFmiss Alm
The CPU blade which was mounted on an indicated slot can't power on in that case.
Check connection between the relevant switch module and the CPU blades to make sure the coincidence of interface.
Notes on starting a dedicated utility when POST is running
To start a dedicated utility for the RAID controller and so on when POST is running, do as follows.
1. Make sure that you do not press any key before beginning this work.
2. Press a "Modifier Key" (such as <ctrl> key) first, and hold down the "Modifier Key" and press a "Character key" (such as
<H> key) with the "Modifier Key" pressed repeatedly until the dedicated utility starts.
If you have failed to start the dedicated utility, please restart the server and rerun POST to try again.
Meaning
Switch module n (n=1-8) interface mismatch