DeWalt D2002M Instruction Manual page 14

ENGlIsh
IMPORTANT SAFETY INSTRUCTIONS
SAVE ALL WARNINGS AND
INSTRUCTIONS FOR FUTURE
REFERENCE

DANGER: RISK OF EXPLOSION OR FIRE
What can happen
It is normal for electrical contacts
within the motor and pressure
switch to spark.
If electrical sparks from compressor
come into contact with flammable
vapors, they may ignite, causing
fire or explosion.
Restricting any of the compressor
ventilation openings will cause
serious overheating and could
cause a fire.
Unattended operation of this
product could result in personal
injury or property damage.
To reduce the risk of fire, do
not allow the compressor to
operate unattended.

CAUTION: RISK FROM NOISE
What can happen
Under some conditions and
duration of use, noise from
this product may contribute to
hearing loss.
12
how to prevent it
Always operate the compressor
in a well ventilated area free of
combustible materials, gasoline, or
solvent vapors.
If spraying flammable materials,
locate compressor at least 20 feet
(6.1 m) away from spray area.
An additional length of hose may
be required.
Store flammable materials
in a secure location away
from compressor.
Never place objects against or on
top of compressor pump.
Operate compressor in an open
area at least 12" (30.5 cm) away
from any wall or obstruction that
would restrict the flow of fresh air
to the ventilation openings.
Operate compressor in a clean,
dry well ventilated area. Do not
operate unit indoors or in any
confined area.
Always remain in attendance with
the product when it is operating.
Always turn off and unplug unit
when not in use.
how to prevent it
Always wear certified safety
equipment: ANSI S12.6 (S3.19)
hearing protection.

DANGER: RISK TO BREATHING
(Asphyxiation)
What can happen
The compressed air directly from
your compressor is not safe for
breathing. The air stream may
contain carbon monoxide, toxic
vapors, or solid particles from
the air tank. Breathing these
contaminants can cause serious
injury or death.
Exposure to chemicals in dust
created by power sanding,
sawing, grinding, drilling, and
other construction activities may
be harmful.
Sprayed materials such as paint,
paint solvents, paint remover,
insecticides, weed killers,
may contain harmful vapors
and poisons.

WARNING: RISK OF BURSTING
air Tank: On February 26, 2002, the U.S. Consumer Product Safety
Commission published Release # 02-108 concerning air compressor
tank safety:
Air compressor receiver tanks do not have an infinite life. Tank life
is dependent upon several factors, some of which include operating
conditions, ambient conditions, proper installations, field modifications,
and the level of maintenance. The exact effect of these factors on air
receiver life is difficult to predict.
If proper maintenance procedures are not followed, internal corrosion
to the inner wall of the air receiver tank can cause the air tank to
unexpectedly rupture allowing pressurized air to suddenly and forcefully
escape, posing risk of injury to consumers.
Your compressor air tank must be removed from service by the end of the
year shown on your tank warning label.
The following conditions could lead to a weakening of the air tank, and
result in a violent air tank explosion:
What can happen
Failure to properly drain condensed
water from air tank, causing rust
and thinning of the steel air tank.
Modifications or attempted repairs
to the air tank.
how to prevent it
Air obtained directly from the
compressor should never be
used to supply air for human
consumption. In order to use air
produced by this compressor for
breathing, suitable filters and
in-line safety equipment must be
properly installed. In-line filters
and safety equipment used in
conjunction with the compressor
must be capable of treating air
to all applicable local and federal
codes prior to human consumption.
Work in an area with good
ventilation. Read and follow the
safety instructions provided on the
label or safety data sheets for the
materials you are spraying. Always
use certified safety equipment:
OSHA/MSHA/NIOSH respiratory
protection designed for use with
your specific application.
how to prevent it
Drain air tank daily or after each
use. If air tank develops a leak,
replace it immediately with
a new air tank or replace the
entire compressor.
Never drill into, weld, or make
any modifications to the air tank
or its attachments. Never attempt
to repair a damaged or leaking air
tank. Replace with a new air tank.