DeWalt D2002M Instruction Manual page 20

ENGlIsh
Model Number _______________________________
Serial Number ________________________________
Date and Place of Purchase _______________________
To Replace Regulator (Fig. A, E)
1. Release all air pressure from air tank. See To Drain Tank
in the Maintenance section.
2. Unplug unit.
3. Remove the console cover.
4. Using an adjustable wrench, remove the safety valve
from the regulator manifold
Remove the hose by removing the hose clamp
NoTE: The hose clamp is not reusable. You must
purchase a new hose clamp.
Fig. E
12
5. Remove three pump mounting screws securing pump.
6. Carefully lift pump up away from brackets and out of
the way.
7. Using an adjustable wrench remove the regulator
8
knob .
8. Apply pipe sealant to new regulator manifold and
assemble, tighten with wrench.
9. Reapply pipe sealant to safety valve.
10. Reassemble all components in reverse order of removal.
Make sure to orient gauges to read correctly and use
wrenches to tighten all components.
Storage
Before you store the air compressor, make sure you do
the following:
1. Review the Maintenance section on the preceding
pages and perform scheduled maintenance
as necessary.
2. Drain water from air tank. See To Drain Tank
under Maintenance.

WARNING: Risk of Bursting. Water will condense
in the air tank. If not drained, water will corrode
and weaken the air tank causing a risk of air
tank rupture.
3. Protect the electrical cord and air hose from damage
(such as being stepped on or run over). Wind air hose
loosely around the compressor handle. Wrap electrical
cord onto the cord wrap.
4. Store the air compressor in a clean and dry location.
18
7
11
.
12 .
Accessories

WARNING: Since accessories, other than those
offered by D WALT, have not been tested with this
e
product, use of such accessories with this tool could be
hazardous. To reduce the risk of injury, only D
recommended accessories should be used with
this product.
Recommended accessories for use with your tool are
available at extra cost from your local dealer or authorized
service center.
Repairs
The charger and battery pack are not serviceable.

WARNING: To assure product SAFETY and
RELIABILITY, repairs, maintenance and adjustment
(including brush inspection and replacement) should
be performed by a D WALT factory service center or a
e
D WALT authorized service center. Always use identical
e
replacement parts.
WALT
e