Miele H 2465 B Manual page 67

Problem
Spots like rust appear
on catalytic enamelled
surfaces.
The FlexiClip runners do
not push in or pull out
smoothly.
The oven interior light-
ing does not switch on.
Cause and remedy
The catalytic cleaning process does not remove
spices, sugar and similar deposits.
 Take the catalytic enamelled panels out of the
oven and remove this type of deposit with a mild
solution of hot water and washing-up liquid ap-
plied with a soft brush (see "Cleaning and care –
Cleaning the catalytic enamelled back panel ").
The bearings in the FlexiClip runners are not suffi-
ciently lubricated.
 Lubricate the bearings with the special Miele lub-
ricant.
Only the special Miele lubricant is designed for the
high temperatures in the oven compartment. Other
lubricants may resinify when heated and will gum
up the FlexiClip runners. You can obtain the spe-
cial Miele lubricant from your Miele dealer or from
the Miele Customer Service Department.
The halogen lamp is faulty.

Risk of injury caused by hot surfaces.
The oven gets hot during operation. You could
burn yourself on the heating elements, oven com-
partment or accessories.
Allow the heating elements, oven compartment
and the accessories to cool before manual clean-
ing.
 Disconnect the appliance from the mains. Switch
off at the wall and withdraw the plug from the
socket or switch off the fuse of the electrical in-
stallation.
 Turn the lamp cover a quarter turn anti-clockwise
to release it and then pull it together with its seal
downwards to take it out.
 Replace the halogen lamp (Osram 66725 AM/A,
230 V, 25 W, G9).
 Refit the lamp cover together with its seal and turn
clockwise to secure.
 Reconnect the appliance to the electricity supply.
Problem solving guide
67