Epson ActionDesk 4000 User Manual page 26

Always wait at least 20 seconds after you turn off the
power before you turn it on again to prevent possible
damage to the computer's electrical circuitry.
Do not leave a beverage near your system. Spilled liquid
can damage the circuitry of your equipment.
Follow these steps to turn on your system:
1. Turn your computer around so the front panel faces you.
Place your monitor, printer, and other devices in a
convenient arrangement.
2. If there is a protective card in the diskette drive, remove it.
3. Turn on the monitor, printer, and any other devices
connected to the computer.
4. Turn on the computer by pressing the power button on the
right side of the front panel.
The power indicator lights up, then the screen displays the
BIOS version number and copyright information. The
computer performs its power-on diagnostics, which are a
series of checks to make sure everything is working
correctly. During diagnostics, you see a message telling you
to press F2 to run the SETUP program. (Chapter 2 describes
starting and using SETUP.)
when the computer completes its testing, it displays a screen
describing the system's configuration. If necessary, press
the Pause button on the keyboard to view the
configuration screen. Then press any key to continue the
startup process.
1-8 Setting Up Your System