Epson ActionDesk 4000 User Manual page 78

Position one of the cache chips over the first socket as shown
below, aligning the pins on the chip with the holes in the
socket. Make sure the small notch on the end of, the chip is
aligned with the corresponding notch on the socket.
5.
Gently press the chip halfway into the socket (to make sure
it is correctly aligned). If the chip goes in at an angle,
remove it and try again.
6.
When the chip is properly positioned, push down firmly on
both ends of the chip to make sure it is well-seated.
7.
Repeat steps 4 through 6 for each of the remaining chips.
8.
Change jumpers J25, J26, J27, and J28, as described on
page 4-8, to match to the amount of cache you installed.
9.
Replace any option cards you removed. See page 4-14.
10. Run SETUP
check that the
options are
Advanced System Setup menu. Make sure you save your
settings as you leave SETUP (see Chapter 2).
When the computer restarts, it displays the amount of external
cache you have installed on the system.
4-24 Installing and Removing Options
to External Cache
enable the
System shadow
enabled. You select these options from the
option and
Video shadow
and