Setting The Jumpers - Epson ActionPC 5000 User Manual

PS/2 mouse jumper settings
Enable PS/2 mouse support
Disable PS/2 mouse support
Note: Enabling PS/2 mouse support reduces your system memory by 1 K. If
you need this extra memory, you can disable PS/2 mouse support and
use a serial mouse.

Setting the Jumpers

To change a jumper setting, follow these steps:
1. Refer to the illustration on page 4-6 to locate the jumpers.
2. If there are any option cards installed in your computer, you
need to remove them to access the jumpers. See page 4-19.
3. A jumper's setting is determined by where the jumper is
placed on the pins. Use the following table to identify the
pin settings for 2-pin, 3-pin, and 4pin jumpers. To identify
pin 1, look at the system board under the jumper. A
triangle is traced on the board at pin 1.
2-3
Installing and Removing options
I
2-3
I
I
4-9