Epson ActionPC 5000 User Manual page 77

4.
Position one of the cache chips over the first socket as shown
below, aligning the pins on the chip with the holes in the
socket. Align the small notch on the end of the chip with
the corresponding notch on the socket.
5. Gently press the chip halfway into the socket (to make sure
it is correctly aligned). If the chip goes in at an angle,
remove it and try again
6.
When the chip is properly positioned, push down firmly on
both ends of the chip to make sure it is well-seated.
7.
Repeat steps 4 through 6 for each of the remaining chips.
8.
Change jumpers J24, J25, J26, J27, and J28, as described on
page 4-8, to match to the amount of cache you installed.
9.
Replace any option cards you removed (page 416); then
replace the computer's cover.
10. Run SETUP to enable the External Cache option on the
Advanced System Setup menu. (See Chapter 2).
When the computer restarts, it displays the amount of external
cache you have installed.
4-24 Installing and Removing Options
notch