Table of Contents
Advertisement
3.3.2
Proper Jumpers Setup
Please refer to Figure 5 above, as well to the pictures provided below.
Powering the kit using USB0:
JP4
JP6
JP7
Powering the kit using X2 and X3:
JP4
JP6
JP7
Quick Start Guide Rev. 1.0
Prior to applying power to the evaluation kit, please make sure that all the
jumpers on the Motherboard are set properly.
In the picture below (circled in Red) are all related jumpers.
Figure 5: MB Jumpers Location
Pin 1 connected to Pin 2
Pin 1 connected to Pin 2
connected
Pin 2 connected to Pin 3
Pin 1 connected to Pin 2
connected
PAN9420 Quick Start Guide
Page 12
Advertisement
Table of Contents
