LG HU641BBG Owner's Manual page 13

global_main.book.book Page 13 Friday, February 24, 2023 1:51 PM
3
On the underneath of the hob, adjust the
brackets into a position that is suitable for your
worktop. Then fully tighten the screws to
secure the hob into position.
Screw Position
d
Gas Connection
NOTE
• This appliance must be installed and connected
in accordance with installation regulations in
force in the country in which the appliance is to
be used.
• This appliance is supplied to run on LPG and
natural gas. Conversion for use on LPG and
natural gases must only be undertaken by a
qualified person.
INSTALLATION
• It is the law that all gas appliances are installed
by competent persons in accordance with the
current edition of the Gas Safety Installation and
Use Regulations.
• It is in your interest and that of safety to ensure
compliance with the law.
• Failure to install the hob correctly could
invalidate the warranty, liability claims and lead
to prosecution.
• The appliance must be connected in accordance
with the currently applicable regulations.
• Before installing the appliance, check that the
local conditions (type of gas and pressure) are
compatible with the appliance settings. The
permissible appliance settings can be found on
the rating plate.
• Connection to the gas lines and seal fitting must
be carried out professionally according to the
currently applicable standards.
Gas Connection on the Appliance
The gas connection is located at the rear right of
the appliance.
Only use connecting lines or flexible hoses (tubes)
which comply with the applicable regulations and
which are approved for this purpose.
Gas supply replacement and installation
guidelines:
• Screw the female threaded elbow and the seal to
the end of the gas pipe.
• Hold the elbow with a wrench and connect the
flexible gas connecting tube (hose) to the elbow.
LNG
13