4: Subsidiary Equipment - Honeywell Notifier NFS2-3030 FACP Programming And Operations Manual

Mass notification system
Hide thumbs Also See for Notifier NFS2-3030 FACP:
Table of Contents

Advertisement

Programming Steps
4 Create MN audio paging group(s).
5 Set up the workstation priorities for an MN CCS station.
3.2.4 Subsidiary Equipment
The panels and network annunciators in this section may be present on an MN network without being part of an ACU, LOC or CCS.
They do not have local control when an MN alarm is active in the system unless fire is the highest priority and there is a fire alarm on the
panel or on a mapped node on the NCA-2. They are capable of initiating and annunciating an MN alarm, but can not perform acknowl-
edge, silence, or reset functions while an MN alarm is active in the system.
1 Set the mass notification priority.
2 Set the DCC field.
3 Map to MN nodes.
4 Program with MN type IDs.
5 Set the MN Control Field to Subsidiary.
6 Program with MN Special Function Zones.
*NFS2-3030 may be in standard or network display mode.
1 Set the mass notification priority
2 Set the DCC field.
3 Map to MN nodes.
4 Program with MN type IDs.
5 Program with MN Special Function Zones.
1 Set the MN Mode.*
2 Set the Associated Node Number field.
3 Program input categories and priorities.
4 Create and program an MN Active Tone.
5 Create and program a Fire Active Tone (when Fire is the highest priority).
*MN paging levels are not installed when the DVC acts as a subsidiary device.
DVC-RPU
MN Paging Levels are not installed when the DVC-RPU acts as a subsidiary device.
Program the DVC-RPU label. Refer to "DVC-RPU" on page 33.
MN Annunciator Programming
Program an annunciator as a dedicated MN alarm annunciator (See page 34). Set an LCD2-80 to terminal mode (See page 34). Use DVC
General Zones Z501 - Z533 to annunciate LOC and ACU paging. Refer to "DVC General Zones" on page 34.
Mass Notification — P/N LS10063-000NF-E:E 06/26/2019
CCS Programming Steps
Subsidiary Equipment Programming Steps
NFS2-3030*/NCA-2
NFS2-640/NFS-320/SYS
DVC
Programming
manual
manual
page 19
page 18
page 23, page 23
page 24
page 35
page 25
page 21
page 18
page 24
page 24
page 25
page 21
page 21
page 21, page 22
page 25
page 29
17

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents