Panasonic WORKIO DP-CL21 Setup Manual page 17

Setup
Step 2: Setting up TCP/IP on the printer
You need to set the IP Address, Subnet Mask and Default
Gateway for the printer. It can be set by using one of the
following three methods.
• Using the DHCP server
• Using the Network Setup Tool
• Using the Printer Panel
If the administrator manages the network with DHCP
server, it will automatically assign an IP Address, Subnet
Mask and Default Gateway. These can be viewed by
printing out the configuration page (see below).
For the instructions of another method, refer to "Network"
section in the Operating Instructions (see "Using the
Manuals" on page 27).
1
Turn the printer on (see "Power On" on page 28).
2
Press MENU/EXIT (PAUSE) button on the printer
panel.
3
Press (CONTINUE) button until Test Page menu
appears.
4
Press ENTER button.
Menu Map item menu appears.
5
Press (CONTINUE) button until Configuration
Page item menu appears.
6
Press ENTER button.
The configuration page will be printed.
7
Confirm the IP Address on the configuration page.
NOTE:
• If the printer receives the IP Address with unlimited
lease term, the printer keeps the address permanently.
The printer saves the address statically and the DHCP
function becomes disable automatically.
Step 3: Installing the printer driver and
utilities
If you want to install the printer driver and utilities using
the network interface cable, be sure to connect the printer
with a network interface cable and to turn it on in advance.
Perform the following steps to complete the installation.
For Windows NT 4.0, Windows 2000, Windows XP
• Log in as an Administrator.
For Windows NT 4.0
• Confirm the LPR port is installed. (Refer to Network
section of the Operating Instructions.)
(1) Click Custom Printer Setup.
(2) Click Install Network Port.
(3) Insert the Windows NT 4.0 CD-ROM and install the
Microsoft TCP/IP Printing Service.
1
Insert the printer CD-ROM disk into the CD-ROM
drive.
The CD-ROM launches automatically.
NOTE:
• If the CD-ROM does not launch automatically,
perform the following steps (1) - (2).
(1) Double click My computer icon.
(2) Double click the CD-ROM icon.
2
Click Automated Printer Setup.
The Select URL Installation window is displayed.
3
Click on the Enter URL during installation check
button and click [Next >].
The URL Setting windows is displayed
4
Enter the URL address of the shop where you
purchased the printer and click [Next >].
The License Agreement window is displayed.
5
Click [Yes].
The Select Printer window is displayed.
6
Select the printer of the IP Address confirmed on the
Configuration Page at Step 2.
7
Click [Next >].
The Installed Device window is displayed.
NOTE:
• The installed devices are already detected and
checked.
8
Click [Next >].
This wizard starts installing the Printer Driver and
Utilities.
The InstallShield Wizard Complete window is
displayed.
9
Click [Finish].
The printer driver is installed after restarting
Windows. (For Windows NT 4.0, Windows 2000,
Windows XP, you must log on the computer as an
Administrator.)
17