Panasonic WORKIO DP-CL21 Setup Manual page 30

Setup
Color Calibration Test Print Page (Example):
CMY
Composite
1
Gray*
*1 CMY Composite Gray is the color mixed CYAN,
MAGENTA and YELLOW. If the color calibration is
proper, the CMY Composite Gray is near gray.
6
Compare the current color density settings on the
Color Calibration Test Print Page with the color
density samples on the Color Calibration Card to see
if they match.
• Place the Color Calibration Test Print Page on at
least 2 sheets of clean white paper in a well-lighted
area.
Color Calibration
Card
• If they match and CMY Composite Gray is proper,
then you do not need to adjust the color density and
you may proceed with any operation you wish to
perform.
• If they do not match, go to the next step.
7
Determine which block on the Color Calibration Test
Print Page most closely matches the density of the
cyan sample on the Color Calibration Card.
• Repeat this step for each color.
8
Proceed to "Adjusting the Density for All Colors
Simultaneously" or "Adjusting the Density for
Each Color Independently".
30
Current
color
density
settings
Clean
white
paper
Color Calibration
Test Print Page
Adjusting the Density for All Colors
Simultaneously
1
Press MENU/EXIT (PAUSE) button on the printer
panel.
2
Press (CONTINUE) button until Color Calibration
menu is displayed.
3
Press ENTER button.
Calibration Offset item menu appears.
4
Press ENTER button.
0* (-5 to 5) selection menu appears.
5
Press (CONTINUE) or
darken/lighten for all the colors to match with the
colors of the Color Calibration Card.
To make the color density setting of the Color
Calibration Test Print Page darker or lighter by 1
level, increase or decrease a value of the Calibration
Offset by 1 by pressing
(CANCEL) button.
For example, when Calibration Offset is 0:
• If you wish to make the density setting darker by 1
level: Select 1 by pressing
once.
• If you wish to make the density setting lighter by 1
level: Select -1 by pressing
once.
6
Press ENTER button.
CYAN item menu appears.
7
Press (CONTINUE) or
Calib. Test Prn. menu is displayed.
8
Press ENTER button to reprint the Color Calibration
Test Print Page.
• The line enclosure and Gray Balance reflects the
changes made to the settings.
• If you are not satisfied with the current color density
settings, repeat the above steps.
(CANCEL) button to
(CONTINUE) or
(CONTINUE) button
(CANCEL) button
(CANCEL) button until