Table of Contents
Advertisement
Installation (ET-WBC100) (continued)
Attention
z Be sure to use the bolts, hex nuts, spring washers, anchoring nuts or curled plugs for M6.
z Tighten the bolts and nuts securely. If necessary, use double nuts or take screw locking measures to prevent loosening.
Installing the projector to the wall mount bracket
Remove the arm cover from the wall mount bracket. (Fig.1)
1)
z Remove the cover from the top side.
With the projector attached, slide the connecting plate on the projector mount bracket kit into the
2)
adjustable unit of the wall mount bracket. (Fig.2)
z The sliding direction of projector mount bracket kit is indicated by the arrow marks on the connecting
plate.
Arm cover
Fig.1
Align the center position of projector mount bracket kit with the center of wall mount bracket.
3)
z Adjust the position of projector mount bracket kit so that the two screw holes on the adjustable unit are
located at the left end of the long holes on the connecting plate. (Fig.3)
Fig.4
Adjustable unit
Screw hole
Fig.5
Arrow marks
Connecting plate
Fig.2
Fig.3
ENGLISH - 13
Advertisement
Table of Contents
