Table of Contents
Advertisement
Making adjustments (ET-WBC100) (continued)
■ If the image is shifted left or right (horizontal slide)
Loosen the four flanged screws (M4 × 10) on the projector mount bracket kit.
1)
Slide the projector mount bracket kit together with the projector to adjust the image to the left or right
2)
side.
After adjustment is finished, firmly tighten the four flanged screws loosened in Step 1).
3)
Note
z If the projected image is shifted or tilted, perform steps (1) to (6) in order. After minimizing image distortions by performing adjustments in
steps (1) to (3), you are recommended to perform adjustments in steps (4) to (6).
(1) Horizontal swing
adjustment
z If keystone distortion occurs in the image after adjusting the installation angle (while keystone correction is not applied in the [POSITION]
menu of the projector), the projector and screen are not positioned correctly in relation to each other. Verify that the projector and screen
face each other directly.
z The wire rope is not shown in the illustrations.
Flanged screws
(3) Horizontal tilt
(2) Vertical tilt
adjustment
adjustment
(5) Forward/
(4) Vertical slide
backward slide
(6) Horizontal slide
ENGLISH - 19
Advertisement
Table of Contents
