Table of Contents
Advertisement
Replacing projector mount bracket (ET-PKC300B)
Removing the connecting plate
Remove the left and right mount covers attached to the wall mount bracket. (Fig.1)
1)
Disconnect cables connected to the projector.
2)
Remove the drop-prevention wire rope fixed to the wall. (Fig.1)
3)
Remove the four flanged screws (M4 × 10) that secure the projector mount bracket kit to the wall
4)
mount bracket. (Fig.1)
z If the brackets interfere with the Phillips screwdriver, making it impossible to tighten the flanged screws on
the wall side, pull out the arm and tighten the screws. For details on how to pull out the arm, refer to "When
adjusting the projected image size (forward/backward slide)" ( x page 16).
Slide the projector mount bracket kit together with the projector to the right to remove them from the
5)
wall mount bracket. (Fig.1)
Place the projector upside down on a soft cloth. (Fig.2)
6)
Remove the four captive washer screws (M6 × 16) that secure the projector mount bracket kit to the
7)
projector. (Fig.2)
Remove the four supplied captive washer screws (M4 × 14) on the projector mount bracket kit so as
8)
to separate the connecting plate from the projector mount bracket. (Fig.2)
Mount covers
Wire rope
20 - ENGLISH
Flanged screws
Fig.1
Captive washer screws (M4 × 14)
Captive washer screws (M6 × 16)
Fig.2
Advertisement
Table of Contents
