Table of Contents
Advertisement
Product description (ET-WBC100)
This is a wall mount bracket (Model No.: ET-WBC100) for installing the projector to a wall.
■ Applicable projectors
PT-CMZ50
Note
z In this manual, the suffixes at the end of the model numbers are omitted.
z Models other than those listed above may also be supported. Check the operating instructions of your projector or the following website.
https://panasonic.net/cns/projector/
■ Structural components
Parts name
Wall mount bracket
Mount cover
Projector mount
bracket kit
Screws
Projector drop-
prevention kit
4 - ENGLISH
Form (number of parts)
Mount cover (L)
× 1
Screw with captive washer (M6×16)
Flanged screw (M4×10)
Screw with captive washer (M6×16)
Wire rope
[3.0 mm (1/8") wire diameter, 750 mm (29-17/32")
length]
Wire rope
[3.0 mm (1/8") wire diameter, 660 mm (25-31/32")
length]
Flat washer (M6)
× 1
Mount cover (R)
× 1
× 1
× 4
× 4
× 1
× 1
× 1
× 1
Applications
This wall mount bracket is installed to the wall to
support the entire product.
In addition to forward/backward and vertical slide
adjustment, it allows vertical and horizontal tilt
adjustment and horizontal swing adjustment of the
projector.
These are attached to the wall mount bracket.
This is used to install the projector to the wall
mount bracket. It consists of a projector mount
bracket and a connecting plate.
It allows horizontal slide adjustment of the
projector.
Used to secure the projector mount bracket kit to
the projector.
Used to secure the projector mount bracket kit to
the wall mount bracket.
Prevents the projector from falling.
Use one of the two wire ropes.
Advertisement
Table of Contents
