Table of Contents
Advertisement
Optional Board Installation Method
1. Analog I/O board
Proceed with the connections in the sequence
described below.
1. Remove the four screws, and remove the analog in
board from analog out board.
2. Connect the cables (for composite signals a3) from
the unit to the analog in board.
Analog audio panel
(packed together with optional board)
AUDIO IN
AUDIO OUT
AUDIO IN
AUDIO OUT
SW 1
SW 2
SW 3
SW1 setting
(for input audio signals with 600-ohm termination) (CH1)
ON: 600-ohm termination
SW2 setting
(for input audio signals with 600-ohm termination) (CH2)
ON: 600-ohm termination
SW3 setting
For the NTSC system (factory setting)
5: OFF
6: ON
For the PAL system (setting must be changed)
5: ON
6: OFF
Input audio level selection
1
+4 dBu
ON
0 dBu
OFF
–20 dBu
ON
(AJ-YA7000P)
ANALOG DIGITAL
REMOTE IN
Rear panel connectors
VIDEO
OUT
IN
(designated channel)
SDI/SDTI
IN
OUT
Red
Black
Orange
Analog in board
SW 5
VIDEO OUT
Analog out board
OFF: High impedance
OFF: High impedance
7: OFF
8: ON
7: ON
8: OFF
2
3
4
OFF
ON
OFF
ON
OFF
ON
ON
ON
ON
3. Orient the analog out board and analog in board so
that the sides on which components are mounted
are facing each other. Place spacers between
them, and attach them together with four screws in
the four places indicated.
4. Install the analog I/O board in the server.
Perform the connections as illustrated below.
Position where terminal resistance is
mounted (No automatic termination.)
SW 9
VIDEO
IN
SW5 setting
Output audio level selection
+4 dBu
0 dBu
–20 dBu
SW9 setting
ON for all switches
32
VIDEO
THROUGH
1
2
3
OFF
OFF
OFF
ON
OFF
ON
OFF
ON
OFF
4
OFF
OFF
ON
Advertisement
Table of Contents
