Table of Contents
Advertisement
Safety information
2.1
General safety information
Safety and commissioning information for converter-fed low-voltage three-phase motors
All activities associated with transporting, connecting, commissioning, and maintaining the
motors must be carried out by properly trained, responsible personnel (DIN EN 50110-1;
note IEC 60364).
Failure to follow proper procedures may result in injury or material damage.
Special versions and construction variants may differ with respect to certain technical
aspects. If in doubt, you are strongly advised to contact the manufacturer specifying the type
designation and serial number (see rating plate) or arrange for any maintenance work to be
carried out by the SIEMENS Service Center.
Systems and machines with converter-fed low-voltage three-phase motors must fulfill the
protective requirements of the EMC Directive.
The machine manufacturer is responsible for ensuring that installation is carried out properly.
The signal and power cables to the motor must be shielded.
The information provided by the converter manufacturer regarding EMC-compliant
installation must be observed.
Proper usage
These motors are designed for use in industrial or commercial systems. They comply with
the EN 60034-1 standards and the relevant associated sections.
It is forbidden to install them in hazardous areas unless they are explicitly designed for this.
If more stringent requirements are necessary in special cases (e.g. shock-hazard protection
in non-commercial applications where children are likely to be present), the customer must
implement the relevant measures to ensure that these requirements are fulfilled.
Any alternative requirements specified on the rating plate must be taken into account. The
on-site conditions must comply with the rating plate specifications.
The motors are designed for use in sheltered areas under normal climatic conditions, such
as those found in production halls.
Synchronous/induction motors 1PH813
Operating Instructions, 04/2009, 610.48000.22
DANGER
WARNING
2
11
Advertisement
Table of Contents
