Husqvarna 1-8DPS30 Operator's Manual page 14

To connect a dust extractor
WARNING:
extractor if the dust extractor hose is
damaged. The risk increases that you
breathe in dust that is dangerous to your
health. Use approved respiratory protection.
1. Examine the dust extractor hose for damages.
2. Make sure that the filters in the dust extractor are
clean and not damaged.
3. Attach the dust extractor hose safely to the
connection for dust extractor. Safety the attached
parts with the supplied tool and industrial tape.
To connect the product to a power
source
1. Connect the power plug of the product to a grounded
mains outlet or other power source.
2. Make sure that the mains voltage agrees with the
type plate on the product.
To do a check of the direction of
rotation of the motor
1. Start the product. Refer to
page 15 .
2. After some seconds, stop the product. Refer to
stop the product on page 18 .
14
Do not use the dust
To start the product on
To
3. Make sure that the blastmotor has the correct
direction of rotation. The correct direction is shown
with an arrow on top of the fan cover.
4. If it is necessary, change the direction of rotation
of the motor. Refer to
rotation of the motor (3-phase only) on page 14 .
To change the direction of rotation of
the motor (3-phase only)
1. Turn the ON/OFF switch to the OFF position.
2. Wait until the product has fully stopped.
3. Disconnect the extension cord from the power plug
on the product.
4. Turn the inverter switch in the power plug on the
product to the opposite position.
To change the direction of
2087 - 001 - 23.02.2023