Husqvarna 1-8DPS30 Operator's Manual page 17

To adjust the blast pattern
WARNING:
or touch the cage clamps, feed spout
and blastwheel when the product is on.
Disconnect the power supply when you
adjust the blast pattern.
WARNING:
equipment when you adjust the blastpattern.
Personal protective equipment on
Refer to
page 6 .
1. Disconnect the power plug.
2. Loosen the 3 nuts and the adjustment lever (A).
A
B
3. Hit the blastwheel cover with a rubber hammer to
adjust the blast pattern (B).
4. When you turn the blastwheel cover, you adjust the
opening of the control cage.
5. Make sure that the feed spout is still in the correct
position after you have adjusted the control cage.
2087 - 001 - 23.02.2023
Do not adjust, loosen
Use personal protective
6. Turn the blastwheel cover clockwise, if the hotspot is
too much on the right side.
7. Turn the blastwheel cover counterclockwise, if the
hotspot is too much on the left side.
17