Cleaning; Cleaning The Blender - Silvercrest SSML 1000 A1 Operating Instructions Manual

Cleaning

Cleaning the blender

SSML 1000 A1
Heruntergeladen von manualslib.de
RISK OF ELECTRIC SHOCK!
Before starting to clean the blender and its components:
► Ensure that the motor is switched off and the power plug removed from the
socket.
Do not immerse the motor block
result in you receiving a fatal electric shock and cause damage to the
appliance.
► Never open the housing of the appliance. Otherwise, there is a risk of a
fatal electric shock.
WARNING! RISK OF INJURY!
► Never disassemble the cutting blades
The cutting blades
CAUTION – PROPERTY DAMAGE!
► Do not use solvents or abrasive cleaners on the plastic surfaces, they could
be damaged by them.
■ To prevent injuring yourself on the cutting blades
with a long-handled washing-up brush.
■ In a case of stubborn soiling, the blender
washer. To do this, always remove the blender
■ Clean the lid and the measuring cap
normal washing up.
If you clean the blender directly after use, you can often achieve a satisfacto-
ry and hygienic level of cleaning by doing the following:
Fill the blender with 750 ml of water and add a few drops of mild
detergent. Close the lid
Insert the plug into a mains power socket and activate the Ice Crush/Clean
operation a few times, so that the cutting blades
at full speed.
Afterwards, rinse out the blender
all detergent residues have been removed.
Handbücher-Suchmachiene
in water or other liquids. This could
and never reach into the blender
are extremely sharp!
can also be cleaned in a dish-
in a dishwasher or with the
and fit the blender
with lots of clean water to ensure that
, clean the blender
, as described later.
onto the motor block
churn through the water
GB │ IE │ NI │ CY │
13
.
only
.
■