This service manual does not describe SPECIFIC SERVICE INSTRUCTIONS.
3.1
Center frame section
3.1.1 Removing the L side cover assembly (See Figure 1, 2,
3 and 4)
(1) Remove the four screws A attaching the L side cover as-
sembly, and then open the L side cover assembly.
A
L Side cover assembly
A
(2) Pull out the wire from the connector
board.
MAIN Board
SPECIFIC SERVICE INSTRUCTIONS
DISASSEMBLY
A
Fig.1
A
L Side cover assembly
Fig.2
CN210
on the MAIN
CN210
L Side cover assembly
Fig.3
SECTION 2
SECTION 3
(3) Pull out the wire from the SDI terminal.
(4) Pull out the wire from the connector
WORK board, and then remove the L side cover assembly
(only GY-HM650).
L Side cover assembly
3.1.2 Removing the R side cover assembly (See Figure 5, 6,
7 and 8)
• Remove the L side cover assembly.
(1) Remove the four screws B and the one screw C attaching
the R side cover assembly.
Screw B: Short
(2) Remove the two screws D attaching the handle cover (R)
and then remove the handle cover (R).
B
R Side cover assembly
CN3112
CN3112
SDI Terminal
Fig.4
Screw C: Long
R Side cover assembly
B
Fig.5
B
B
Fig.6
(No.HC047<Rev.001>)1-5
on the NET-