JVC GY-HM600U Service Manual page 6

D
Handle cover (R)
D
(3) Pull out the FFC wire from the connector
GAIN board, and then remove the R side cover assembly.
GAIN Board CN1412
R Side cover assembly
3.1.3 Removing the MAIN board and NETWORK board (See
Figure 9 and 10)
• Remove the L side cover assembly.
(1) Remove the three screws E attaching the bracket (DCIN)
and heat sink plate, and then remove the bracket (DCIN)
and heat sink plate.
• When attaching the bracket (DCIN) and heat sink plate,
a bracket (DCIN) is under a heat sink plate.
E
Bracket
(DCIN)
E
1-6 (No.HC047<Rev.001>)
C
Fig.7
CN1412
Fig.8
Heat sink plate Heat sink plate Heat sink plate
E
Fig.9
(2) Pull out the wires from the connectors CN203, CN201,
CN207, CN214, CN208, CN213, CN209, CN212, CN202,
CN204, CN205, CN206,
board.
(3) Remove the one screw F attaching the MAIN board, and
then remove the MAIN board.
(4) Remove the two screws G, and then remove the NET-
WORK board (only GY-HM650).
CN208 CN207
CN214
on the
CN213
3.1.4 Removing the SDSLOT board (See Figure 11)
• Remove the R side cover assembly.
(1) Pull out the wire from the connector
SLOT board.
(2) Remove the two screws H attaching the SDSLOT board,
and then remove the SDSLOT board.
CN809
3.1.5 Removing the rear assembly (See Figure 12 and 13)
• Remove the L side cover assembly and R side cover assembly
etc, .
(1) Remove the one screw J and the five screws K attaching
the rear assembly, and then remove the rear assembly.
Screw J: Silver Screw K: Black
CN215 and CN216
CN203
CN215
H G
CN201
MAIN Board MAIN Board MAIN Board
CN204 G
CN209
CN202
CN212
Fig.10
CN809
H
H
Fig.11
J
Fig.12
on the MAIN
CN216
CN206
CN205
on the SD-
SDSLOT
Board
Rear
assembly