Table of Contents
Advertisement
en Troubleshooting
Fault
Wipeable or water-sol-
uble coatings are
present inside the ap-
pliance or on the
door.
Stubborn white coat-
ings are present on
tableware, inside the
appliance or the door.
Tea residue or lipstick
marks on tableware.
58
Cause and troubleshooting
Special salt dispenser is not screwed tight.
Screw the special salt dispenser tight.
▶
Detergent substances are deposited there. These
coatings cannot generally be removed with chemicals.
Change your detergent → Page 34.
▶
Clean the appliance mechanically.
▶
Hardness range is set incorrectly or the water hard-
ness is too high.
→ "Overview of water hardness settings", Page 30
Set the Water softening system to the water hard-
▶
ness or add special salt.
3in1/organic/eco detergent is not effective enough.
Set the Water softening system to the water hard-
▶
ness and use separate detergents (proprietary de-
tergent, special salt, rinse aid).
Too little detergent is being used.
Increase the amount of detergent used or change
▶
Detergent → Page 34.
Washing programme selected too weak.
Select a more intensive washing programme.
▶
→ "Programmes", Page 19
Adjust the sensitivity of the sensors.
▶
→ "Sensors", Page 12
Washing temperature is too low.
Select a programme with a higher washing temper-
▶
ature.
→ "Programmes", Page 19
Too little detergent is being used or is unsuitable.
Use a suitable Detergent → Page 34 and follow the
▶
manufacturer's instructions for the amount to be
used.
Tableware has been precleaned too intensely. The
sensors chose a weaker programme. Stubborn soiling
cannot be entirely removed.
Only remove large remnants of food and do not
▶
prerinse tableware.
Adjust the sensitivity of the sensors.
▶
→ "Sensors", Page 12
Advertisement
Table of Contents
