Table of Contents
Advertisement
en Troubleshooting
Fault
Refill indicator for spe-
cial salt does not light
up.
Refill indicator for
rinse aid lights up.
Refill indicator for
rinse aid does not
light up.
Water is left in the ap-
pliance at the end of
the programme.
Appliance cannot be
switched on or oper-
ated.
Appliance does not
start.
Programme starts
automatically.
Appliance stops dur-
ing the programme or
cuts out.
62
Cause and troubleshooting
Water softening system is switched off.
Set the water softening system.
▶
→ "Setting the water softening system", Page 31
Insufficient rinse aid.
Add Rinse aid → Page 33.
1.
Set the amount of rinse aid to be dispensed.
2.
→ "Setting the amount of rinse aid", Page 33
Rinse aid system is switched off.
Set the amount of rinse aid to be dispensed.
▶
→ "Setting the amount of rinse aid", Page 33
Filter system or area under the filters is blocked.
Clean the Filters → Page 47.
1.
Clean the Wastewater pump → Page 65.
2.
Programme has not yet ended.
Wait until the programme ends or cancel the pro-
▶
gramme with Reset.
→ "Terminate programme", Page 40
▶
Software update is taking place.
Wait until the software update has finished.
▶
Appliance functions have failed.
Pull out the mains plug or switch off the fuse.
1.
Wait at least 2 minutes.
2.
Connect the appliance to the power supply.
3.
Switch the appliance on.
4.
The mains fuse has tripped.
Check the relevant fuse.
▶
Mains cable is not inserted.
Check whether the socket works.
1.
Check whether the mains cable is properly inserted
2.
in the socket and on the rear of the appliance.
Appliance door is not closed properly.
Close the appliance door.
▶
You did not wait until programme ended.
→ "Terminate programme", Page 40
▶
Appliance door is not closed properly.
Close the appliance door.
▶
Power and/or water supply has been interrupted.
Check the power supply.
1.
Check the water supply.
2.
Advertisement
Table of Contents
