Table of Contents
Advertisement
Electrical connection
Some models have two side-mounted power outlets: the power socket on these cookers
●
●
are rated at 250V 10A AC only.
ONNECTION: INFORMATION FOR THE INSTALLER
We recommend that the cooker sub circuit is protected by a suitably rated Miniature
●
●
Circuit Breaker (M.C.B) but not connected to a Residual Current Device (R.C.D) or an
Earth Leakage Breaker (E.L.C.B). In New Zealand this appliance must be connected to
he electrical supply by a suitably registered person.
the electrical supply using a cable fitted with an appropriately rated plug. The plug must
an cause a safety hazard.
be compatible with the socket-outlet fitted to the final subcircuit in the fixed wiring that
ll supply circuits must be disconnected. Failure to do so may result
is intended to supply the appliance.
Single phase connection:
circuit is protected by a suitably rated Miniature Circuit Breaker (M.C.B.)
The supply cable should be at least equivalent to an ordinary PVC sheathed and
●
●
nt Device (R.C.D.) or an Earth Leakage Circuit Breaker (E.L.C.B.).
insulated min. 4 mm
d to the electrical supply using a cable tted with an appropriately rated plug. The plug
Two-phase connection:
tlet tted to the nal subcircuit in the xed wiring that is intended to supply the appliance.
The supply cable should be at least equivalent to an ordinary PVC sheathed and
●
●
insulated, min. 2.5 mm
between 2 and 3 should be removed, as shown. Failure to this will result in damage to
uivalent to an ordinary PVC sheathed and insulated, min. 4 mm
the appliance.
cable.
uivalent to an
min. 2.5 mm
,
2
nd '3' should
is will result
This appliance must be connected to a circuit which incorporates an isolating switch
●
●
providing full disconnection from the power supply.
If you raised the cooker to align it with the bench, make sure the base of the cooker
●
●
cannot slip.
Connecting the cable
1 Remove the cable access cover (lower right hand corner).
r
2 Provide a minimum of 1 metre of cable.
For 220-240 single phase operation, connect phase wire to terminal 1
●
●
(with links between 1-2 and between 2-3 fitted).
For 380-415V two phase operation, remove the link between 2-3 and connect phase 1
●
●
wire to terminal 1 (with link between 1-2 fitted); then connect phase 2 wire to
terminal 3.
3 Connect neutral wire to terminal 5 (with link between 4-5 fitted).
4 Connect ground wire to
earth terminal
5 Replace cover; check that no
conductors are trapped by
MODEL OR61S2L
the wiring cover.
,
,
iNSTALLATiON iNSTrUCTiONS
, three-core (twin and earth), min. 1 m long flexible cable.
2
, four-core, min. 1 m long flexible cable. If fitted the bridging link
2
.
, three-core
2
Remove for two-phase
connection
MODEL OR61S2L
5
Advertisement
Table of Contents
