Connection Status Display - HP 4084B Operation Manual

Model 4 0 8 5 M
Figure 3 - 1 3 lists a sample program that illustrates the use of the S W M COM block in a
user-written subprogram.
below.
Dcs :
S w m :
Pin_port (1:48) :
0 :
1 through 6 and 8 through 1 0 :
-32768 :
, When used in a user-written subprogram, these variables can be
-referenced, but they cannot b e redefined.
U U U
2345 6 7 8 9 0
+ + + +
T t t t t t t t t t t t t + t t + t t + + + + + I!i + t t t
+ t t t +- t t t t t + t t t t ++I!-++ + t t t +
+ t t t t + t t t t + t .. t t + t t t + !!l+ + + + t 'H- t
Vs l
+ t t t t
N Vs2
+ t t t t
A
M
+ t + + + + t t t t
\lm 1
E Vm2 + t t t t
1
+ t t t t t i t t + + t t + + + t t t t + t t t t + +.+ +
L GSHU
CD
Port names
CD
Pin numbers (each pin number is written vertically).
CD
The
(colu mn) are not connected.
The
(column) are connected.
The "-" symbol indicates that the pin board is not installed in the 4085A.
Each variable declared in the S W M C O M block is described
Integer variable for the HP-lE select code and address of the
4145A. This variable is defined as 7 1 7 , but it can be changed as
described in paragraph- 3-32.
Integer variable for the HP-lE select code and address of the
4084A. This variable is defined as 722, but it can be changed as
described in paragraph 3-3 2 .
Integer variable array that stores the connection status o f the
m easurement pins.
Each array element can take on any valid integer value, but only
those listed below have significance.
The m easurement pin is not connected to a measurement port.
m easurement port that corresponds to the stored number.
Table 3-3 for a listing of the port numbers.
The m easurement pin board is not installed.
P I N NUHE:ER
22222
1 2 345 6789
+ t t t t + + + t + t t + + + + T
+ t t t + t t ·H · C III + t T t t + t t t t
+ t + + + + + t t + + t + + +
t t t t t
t + t t t + t t t ;! . l + t t t t i + t +
t + + + + + t t t t + t + + + + t t t +
"+"
symbol indicates
" @ "
symbol indicates that
Figure 3-1 2 . Connection Status Display
Array subscripts correspond to pin numbers.
The m easurement pin is connected to the
Note
2') '"':" )
1 2 345 67890 1 2 345 678
r + t i -
t t t + t t t t t + + t + + + + + +
t t t t t t t t t t t t + t t + + +
+ + + � - + t t t t + + t + + + t t t t + + +
t of + + + + t t t t + t t t t
+ t t + t t t t + + t t t t + t t t t + + +
+ + + -
+ t t t + + t t + + + t t t t + + +
+ t t + + + t t + t t t + + +
+ + + + t t t + + t t + + + t t t +
+ + + + + + + + + + + + + + + + + +
that the corresponding
the corresponding port (row) and pin
Section III
'
Refer to
@ CONNECTED
-
+ + +
+ + +
+ + +
port (row) and pin
3-21