Toro Vista 08924 Vista 08924TC Operator's Manual page 19

•
Keep away from potential hazards, such as edges
of ramps and platforms.
•
Always watch out for and avoid low overhangs
such as tree limbs, door jambs, overhead
walkways, etc.
•
Look behind you before reversing the machine to
be sure of a clear path.
•
When using the machine on public roads, follow
all traffic regulations and use any additional
accessories that may be required by law, such as
lights, turn signals, slow-moving vehicle (SMV)
signs, and others as required.
•
It can take longer to stop the machine on wet
surfaces than on dry surfaces. To dry out wet
brakes, drive slowly on a level surface while
putting light pressure on the brake pedal.
•
Use extreme caution and slow down when driving
the machine in wet or icy areas or on loose terrain
could result in reduced traction, steering, stability,
and braking. Repair areas of loose terrain, if
possible, or close off the area and post a warning
to prevent others from operating the machine on
those areas.
•
Operating the machine at high speed and then
quickly stopping may cause the rear wheels to lock
up, which impairs your control of the machine.
•
Do not leave a running machine unattended. The
machine is considered unattended when you are
7.6 m (25 ft) or more from it, which remains in
view, or whenever you leave the machine and it is
not within view. Whenever you leave the machine
and are within 7.6 m (25 ft) of the machine and
it is still in view, ensure that the parking brake is
engaged to prevent the machine from moving.
•
Before you leave the operating position, do the
following:
– Park the machine on a level surface.
– Ensure that the parking brake is engaged.
– Shut off the machine and remove the key.
– Wait for all movement to stop.
•
If the machine ever vibrates abnormally, stop
and shut off the machine immediately, wait for
all movement to stop, and inspect for damage.
Repair all damage to the machine before resuming
operation.
•
Do not park the machine or leave it unattended
where it obstructs fire aisles, access to stairways,
or fire equipment.
•
Operate the machine only while in the operating
position. You and your passengers should remain
seated whenever the machine is in motion.
•
Do not allow passengers to distract you either
physically or verbally while you are driving the
machine.
•
Make starts, stops, turns, or direction reversals
smoothly so as not to endanger passengers or
lose control of the machine.
•
Always be aware of and watch out for pedestrians.
Do not drive the machine in a manner that
endangers others.
•
Under all travel conditions, operate the machine at
a speed that allows you stop it safely.
•
Yield the right of way to pedestrians, ambulances,
fire trucks, vehicles, or other machines in
emergency situations.
•
Do not pass another machine traveling in the same
direction at intersections, blind spots, or at other
dangerous locations.
•
Keep a clear view of the path of travel, observe
other traffic and personnel, and maintain a safe
clearance.
•
Slow down or stop, as conditions dictate, and
activate the sound-producing warning device at
cross aisles and when visibility is obstructed at
other locations.
•
Do not drive the machine onto any elevator
unless specifically authorized to do so. Approach
elevators slowly, and then enter squarely after
the elevator car is properly leveled. Once on the
elevator, ensure that the parking brake is engaged
and shut off the machine. Have all others leave the
elevator before you enter or exit in the machine.
•
Do not operate the machine when there is the risk
of lightning.
•
Do not add to or modify the machine.
•
Use accessories and attachments approved by
The Toro® Company only.
Slope Safety
•
Slopes are a major factor related to loss-of-control
and tip-over accidents, which can result in severe
injury or death.
•
Survey the site to determine which slopes are
safe for operating the machine and establish your
own procedures and rules for operating on those
slopes. Always use common sense and good
judgment when performing this survey.
•
If you feel uneasy operating the machine on a
slope, do not do it.
•
Keep all movement on slopes slow and gradual.
Do not suddenly change the speed or direction of
the machine.
•
Avoid operating the machine on wet terrain. Tires
may lose traction. A rollover can occur before the
tires lose traction.
19