Using The Mop Nozzle - LG A937KGMS.EIGELGA Owner's Manual

3
Press the battery down into the compartment.
NOTE
• Insert the auxiliary battery completely. If the
auxiliary battery is inserted correctly, the
auxiliary battery icon (
• The auxiliary battery icon (
display flashes during charging and then lights
up briefly and turns off to save energy when
charging is complete.

Using the Mop Nozzle

Before Use
• You cannot adjust the rotation speed of the mop
plates on the mop nozzle.
• To prevent product damage, the mop plate will
automatically stop if there are foreign objects
stuck in the plate or if it is subjected to a strong
impact. Turn the appliance off immediately and
remove the foreign objects or obstructions
before resuming use.
• If you hear a noise while mopping, the mop pad
may have dropped off the mop plate. Turn off
the product immediately and reattach the pad to
the mop plate before resuming use.
• Do not use a soiled mop pad to clean floors.
• Set the water adjustment button to the STOP
position before carrying the appliance around
with the mop nozzle attached.
• Use only authorized LG Electronics mop pads.
• Take care not to accidentally hit the Water
Adjustment button at the rear of the mop
nozzle while cleaning around chairs or table
legs. The water supply level could change or be
turned to off.
Using the Mop Nozzle
This accessory is only available on some models.
) flashes.
*
* ) in the status
When the mop nozzle is attached, the suction is
turned off and only the mop function operates.
Press the Power button to turn the mop on/off.
t
• The rotation speed of the mop plates is constant
and cannot be adjusted.
CAUTION
• Do not assemble or disassemble the nozzle while
the appliance is turned on. Doing so may result
in injury.
• Set the water adjustment button to the STOP
position when not using the appliance for an
extended period of time. Failure to do so may
result in product failure.
• Do not let the appliance stand on the floor while
the wet mop pads are attached. Doing so may
result in damage or swelling to wood flooring.
• Do not use on PVC or polyurethane mats for
infants or children. Friction can cause the motor
to overheat.
NOTE
• If you use the mop nozzle for a long time, the
motor may overheat. (Recommended maximum
run time is 80 minutes.) If the motor overheats, a
safety function is activated and the appliance
automatically turns off. Set the appliance in a
cool, well-ventilated place and allow it to cool
down for about an hour before resuming use.
Filling the Water Tank
Before mopping, you must fill the water tank and
attach it to the mop nozzle.
1
Press the PUSH button
water tank from the mop nozzle.
2
Open the water inlet cap
water tank and fill the tank with water using
the water tank filler
• Open only one water inlet cap to fill the
water. Opening both caps may cause the
water to flush.
• Do not fill the tank over the MAX line
• Do not use detergent or any liquid other
than water in the water tank.
OPERATION
to remove the
a
on the side of the
b
.
c
.
d
17