Troubleshooting - Husqvarna V554 Operator's Manual

To lubricate the front wheels
• Remove the dust cap (A). Grease the nipple (B)
with a grease gun until grease comes out from
the top washer.
A
C
• Lubricate the joint bearing of the front wheels (C)
with a grease gun until grease comes out.
To lubricate the cutting deck
spindles
1. Set the cutting deck in mow position.
Troubleshooting schedule
If you cannot find a solution to your problems in this
operator's manual, speak to your Husqvarna service
agent.
Problem
Engine does not start.
1995 - 002 - 05.12.2022
B

Troubleshooting

Cause
The drive of the blades is engaged. Refer to
Off) button on page 4 .
Steering controls are not locked in the neutral position.
The battery is too weak. Refer to
17 .
There is dirt in the carburetor or the fuel line.
The fuel filter or fuel line is clogged.
The ignition system is damaged.
Incorrect neutral adjustment. Refer to
tion on page 19 .
2. Lubricate each cutting deck spindle 2-3 strokes.
Note:
Use a grease gun with a rubber hose
when you lubricate the cutting deck spindles.
To charge the battery on page
PTO (Power Take-
To adjust the neutral posi-
25